Useful Downloads

Target Shooter Magazine 

The is an online Shooting Magazine. Click Here.

Paper Targets to Print 

Targets 1.pdf Targets 1.pdf
Size : 3.813 Kb
Type : pdf
Targets 2.pdf Targets 2.pdf
Size : 0.035 Kb
Type : pdf
Targets 3.pdf Targets 3.pdf
Size : 0.628 Kb
Type : pdf
Targets 4.pdf Targets 4.pdf
Size : 0.193 Kb
Type : pdf

Bell Target Plans 

BT1001-01 (Target Plate) Drawing.pdf BT1001-01 (Target Plate) Drawing.pdf
Size : 40.679 Kb
Type : pdf
BT1003-01 (Back Plate) Drawing.pdf BT1003-01 (Back Plate) Drawing.pdf
Size : 33.764 Kb
Type : pdf
BT1004-01 (Hanger Bar-Brackets) Drawing.pdf BT1004-01 (Hanger Bar-Brackets) Drawing.pdf
Size : 38.153 Kb
Type : pdf
BT1005-(A)01 (Reset Rod) Drawing.pdf BT1005-(A)01 (Reset Rod) Drawing.pdf
Size : 36.705 Kb
Type : pdf
BT1006-01 (Release Lever).pdf BT1006-01 (Release Lever).pdf
Size : 29.972 Kb
Type : pdf
BT1007-01 (Plunger).pdf BT1007-01 (Plunger).pdf
Size : 34.749 Kb
Type : pdf
Bell_ Target Make.doc Bell_ Target Make.doc
Size : 889.5 Kb
Type : doc

 The above plans are quite a complicated mech as you can see from the one below this version is far simplier and works just as well.

I recently had to replace some parts on one of my Clubs Targets  and took the chance to Photograph it. The maker is not known but it has been sujested its made by Gerstenberger & Eberwein a now closed company.

Bell Target Shooting

 Rear, Shows the Bell and the Adjuster Screw.

Bell Target Shooting

Shows the adjuster Screw and Spring 

Bell Target Shooting

All held togeter by a bolt and two washers. 

Bell Target Shooting

Removal of the Face Plate shows the pitted Plunger 

Bell Target Shooting

The Plunger removed and return spring disconected. 

Bell Target Shooting

The Key Hole where the Plunger operates the Target 


- 

 

Bell Target Shooting

Close up of the new plunger in place. 

Bell Target Shooting

Fit the new Face Plate. 

Bell Target Shooting
Bell Target Shooting

New Parts to be fitted. A Face Plate and a Plunger. 

Bell Target Shooting

A Simple Clanger. 

Bell Target Shooting

The Current Face Plate well pitted by years of impacts. 

Bell Target Shooting

Shows the spacers under the paint as well as years of paint. 

Bell Target Shooting

Years of paint cleaned off the front 

Bell Target Shooting

New Plunger Inserted and spring refitted. 

Bell Target Shooting

Back reassembled and adjuster screw fitted. 

Bell Target Shooting

All re assumbled. 

 

 

 

All back in its box  ready for painting and shooting at.

It still needs adjusting to the right pressure for split shots on the bull.

I also took the chance to fit a low energy bulb which gives a better more even light over the face pate.

Make a free website with Yola